I will then make sure my ports/server settings are correct. For example, if I try to access my server VIA the public IP, and I get hit on my policy – I know that everything is correct on my VIP. I have used the hit counter many times to troubleshoot my VIPs not working. The hit counter should be there by default, but if not add it in by right clicking on the tool bar and selecting Count as one of your columns. you can also check the hit counts on the policy (See below). One way would be to test it, does your server answer? You can also do an online port scan using any many tools online. If you are not sure if your VIP is working, there are many ways to check/troubleshoot. That’s It! Fortinet makes it very easy to create these VIPs.
![fortinet vpn on different ip fortinet vpn on different ip](https://help.zscaler.com/downloads/zia/traffic-forwarding/ipsec/ipsec-vpn-configuration-guide-fortigate-60d-firewall/the_primary_and_secondary_ipsec_tunnels_from_a_fortigate_60d_firewall_to_two_zscaler_zens.png)
If you require any UTM features to be on, this is the time. In 5.2> it is on by default when you create a policy. You then have to specify the server you want to allow in, I am creating the VIP to allow HTTP into the network, so I will only specify HTTP traffic to be allowed in.įor traffic coming into the firewall we do not need to NAT this traffic, please turn this off. Its different then normal address objects, thus specifying, if your name didn’t, that this is a VIP. The destination address will be the VIP you created. Destination address, this is the tricky part. Outgoing interface: this is were the traffic is going, in this case its going to my server located on my LAN interface. Source users, and devices can be left blank. Source address: this would be the actual address its coming from, in this case it could be anyone on the internet, so I will select all. The settings read like this : Incoming Interface – This would be where traffic is coming from, in this case the WAN1 interface. Lets navigate to Policy & Objects, Policy, IPV4 then create a new policy.īelow shows the settings. We have to add a Firewall policy to allow that traffic to the VIP. But, as of now no traffic will be allowed to go to the private server. In this example I am allowing port 80 on my public IP to be forwarded to port 80 on my private server. If you do a Port Forward, select the protocol, and then set the ports.
![fortinet vpn on different ip fortinet vpn on different ip](https://support.huaweicloud.com/intl/en-us/admin-vpn/en-us_image_0175543329.png)
You will then have the option to do a port forward (1 port or a range forwarded into the server), or a 1-1 nat, where all ports are forwarded. Then select the incoming interface, and apply the correct IP information. So, start out naming the VIP something that will have meaning to you. In this example my outside web server listening address is 2.2.2.1 (my fake public IP), my internal web server at 172.16.1.10 and my answering interface (the interface accepting connections) is WAN1 (QXnet). Now, lets input the information needed to have external connections reach our internal network. First lets navigate to Policy & Objects, Objects, and Virtual IPs. Before this firewall will allow traffic to access the NAT object (VIP) it needs to have a Firewall policy allowing the destined traffic to the VIP. Basically, its a NAT object consisting of external IP and port and Internal IP and port. So what is a VIP, a Virtual IP is one way to allow external traffic going to a Public address to be forwarded in to a Local server with a Private address. Remember all the best documentation is located at This entry is for a VIP and Policy creation on firmware 5.2>. Hello, I noticed one thing I have never created a blog entry on creating a Virtual IP to allow access from the internet into a local server.